Logo
FULL SITE MENU
1

1984 Tidecraft

New member
Joined
Last seen
Messages
10
Reaction score
0

Latest activity Postings About

    • 1
      1984 Tidecraft replied to the thread Clutch Dog Position.
      Hello, I am doing some maintenance on the steering system on my 1983 Johnson 115 hp motor. I have two steering cables that connects to...
      • Boat Grease Fitting.jpg
      • Boat Steering Rods.jpg
    • 1
      1984 Tidecraft replied to the thread Clutch Dog Position.
      OK, thank you so much for your help.
    • 1
      1984 Tidecraft replied to the thread Clutch Dog Position.
      OK, thanks. Another question I have. I replaced the pinion bearing. As far as I can tell, I put the new bearing right where the old...
    • 1
      1984 Tidecraft replied to the thread Clutch Dog Position.
      OK, thank you very much for the information. I wonder why they include it with the kit? Everything else in the kit is for the lower...
    • 1
      1984 Tidecraft replied to the thread Clutch Dog Position.
      Hello all, I am rebuilding my lower gear unit on my 1983 Johnson 115 HP V4 and I ordered seal kit, part number 18-2692 from Marine...
    • 1
      1984 Tidecraft replied to the thread Clutch Dog Position.
      I did replace the bearing above the pinion gear. The bottom of the driveshaft looks good. I also have a seal kit. I will have to...
    • 1
      1984 Tidecraft replied to the thread Clutch Dog Position.
      Hello Racerone, I went to take pictures of the new clutch dog, and I found some writing on it showing which end goes towards the...
    • 1
      1984 Tidecraft replied to the thread Clutch Dog Position.
      I live in a rural area in TX and I originally took it to the local boat shop. I have not used/started my boat in about five years. The...
    • 1
      1984 Tidecraft replied to the thread Clutch Dog Position.
      From Marine Engine. I asked the Salesman at Marine Engine I ordered it from if he knew which way it should be installed, and he didn't...
    • 1
      1984 Tidecraft posted the thread Clutch Dog Position in Johnson Evinrude Outboard Forum.
      Hello, I have a 1983 Johnson 115 HP V4 motor. I am replacing the clutch dog on it. I noticed the old and new clutch dog have splines...
    Show older items
  • Loading…
  • Loading…
Back
Top