Logo
FULL SITE MENU

Recent content by Nick0151

  1. N

    Retro fitting tilt and trim 1982 70hp

    Yeah you would think with its rich maritime heritage, but we have 2 boat / outboard places that i know of, both are very nice and welcoming but this is not what they do more buy and sell new and used ones and services for boats or boat parts / motor parts. we dont really have the infrastructure...
  2. N

    Retro fitting tilt and trim 1982 70hp

    Im in Liverpool in the UK
  3. N

    Retro fitting tilt and trim 1982 70hp

    apologies for all the questions, thrust pad is this the pads?
  4. N

    Retro fitting tilt and trim 1982 70hp

    so would this fit on mine being from a v6? thanks 150 v6
  5. N

    Retro fitting tilt and trim 1982 70hp

    Went out today and yeah see what you mean now, you don’t happen to know what year range would be compatible with mine?
  6. N

    Retro fitting tilt and trim 1982 70hp

    Thanks Racerone think should pass and look for an older one? Or what type of adjustment would be needed
  7. N

    Retro fitting tilt and trim 1982 70hp

    Hi all, Just browsing eBay came across a cheap tilt and trim assembly. Does anyone know if this would fit my 1982 evinrude 70. It does not have tilt and trim now. But handy with electronics will make a wiring harness for it with relays and be sure it’s fused. The one below is from a newer 1994...
  8. N

    Bf20 seized now for sale is it worth it?

    Bet you did watch a guy on YouTube all he does is record the ramps funny some people on there 🤣🤣 Well big thank you again for the help and advice! Plan now is full service and get it out on the water soon!
  9. N

    Bf20 seized now for sale is it worth it?

    Funny enough that’s exactly what we did stuck a screw in it and it stopped the leak 🤣🤣 I was surprised just how well it ran. I think the previous owner didn’t know what he was doing we came to the agreement that it must have stalled out and tried to pull it in gear and thought it had seized no...
  10. N

    Bf20 seized now for sale is it worth it?

    Ok went round today took bottom end off impeller one vane was gone.. Done compression test near on 175 top and bottom. The green light was on yes. Went over it and yeah it seems totally fine when put it back together pumps water fine ran it good half hour at high idle no issues.. One...
  11. N

    Bf20 seized now for sale is it worth it?

    my friend brought the outboard, The impeller is dead, What are your thoughts To me it seems ok I said we will do some tests tomorrow, he paid £700 for it. I said we would do Drop test Compression test Drop the bottom end Hook up a hose to the water tube and run it up to temp Then...
  12. N

    Bf20 seized now for sale is it worth it?

    Thank you both he’s decided to leave this one and continue looking for another
  13. N

    Bf20 seized now for sale is it worth it?

    My friend is looking to buy a BF20 (2010) that the seller said it was running then just stopped, he tried to start it but was locked up. After some time as in months it’s started again is it worth about half of what a used one is going for.. he will be essentially paying £900 for a motor that is...
  14. N

    New controls

    Was something i thought about doing never got round to but this video is really helpful.
  15. N

    1982 Evinrude 70HP Idle Timing?

    The service manual says this i take it that is the point the cam follower start to move the carb plates open?
See more
Back
Top