I've checked Leroy's ramblings its pretty good site for getting information on this topic but I've run into a problem. I have the bearing, forward gear the the piece that the clutch dog goes onto clutch dog installed but I can't get the prop shaft with the two bbs with the spring installed...
i was heading back from great day of fishing when all of a sudden my motor dropped rpm and died. i let is sit for a minute and the put it in neutral and pulled the cord and it started right up put it in forward and it died. i started it again and put it in reverse and it ran, then i put it in...
i I had like this sludge on my spark plugs so I tore the head off and the Pistons tops were covered in the same stuff i think it came from the out of the propeller maybe some gear oil got mixed with water and it went into the bucket I was using to cool my engine my question is how did this stuff...
I recently rebuilt the car it looks perfect so when I go to start it will start but it will only run for like 5 seconds and then it dies has a new fuel pump new plugs it had died on me when I was out in the ocean after running it for a few miles its starting to slow a full throttle and then it...
hi im new to the forums i have a 15hp motor that has developed a hole in the mid section below the motor it started has a crack spitting out water I tried to patch it and it just grew into a larger hole. I'm not sure what could have caused this ,a leak in the water pump system. any help would be...