Logo
FULL SITE MENU

Search results

  1. S

    Are there any real disadvantages to using a single LH unit on a tritoon vs a RH unit?

    I purchased a lower unit listed as a RH drive but it turns out the unit is LH. I honestly thought it was RH until I checked it against my old one. The unit is pretty much brand new otherwise, seller said it was one of a pair of spares he obtained as part of a government auction where he was...
  2. S

    BF225 Lower unit shift shaft removal

    Kinda puzzled on this. I'm trying to remove the shift shaft so I can remove the prop shaft assembly. Water pump and housing is all removed, It is in neutral as the shop manual says. I easily got the shift rod holder (the round plastic thing with the O-ring) out of the case with no problem, but...
  3. S

    2004 BF225 25" extension case driveshaft bearing (bushing) question

    Bought an almost new lower unit for for my 2004 BF225 XA (25") and long story short, what I actually got was a 30". The seller offered to take it back and get the shaft reworked to the correct length. I just got it back and the shaft length matches the old one perfectly, however, the thickened...
  4. S

    2004 BF225 Extension case rubber question (and a few others)

    I went to change my oil in the lower unit of my 2004 BF225 (purchased used 2 years ago) and it had water in the case with the oil. It turns out the gear case has severely corroded, and the wall of the shift shaft is where it is leaking. The wall was actually missing in about 3 spots and you...
  5. S

    2004 BF225 ECM

    Had trouble with check engine light bieing on and getting error codes off my 2004 BF225 and after walking through the repair manual, it says I need to replace the ECM. Looking on boats.net, it gives the part as 34750-ZY3-043, however the part that came off was 34750-ZY3-023. I assume at some...
  6. S

    BF225 Check engine light connection to motor

    For some reason my boat (bought used) did not have a check engine light or alternator light (but does have the temp and oil pressure ones). The engine is a 2004 Honda BF225. I decided to add one of the 4 way combo ones in a 2" gauge spot in the dash since I had a spot open. I got it plugged in...
  7. S

    Weird BF225 starting behavior

    I have a 2004 BF225 and it runs great, but it is doing something weird when starting. When the engine has sat for a while (a day or so) without starting, I prime the bulb, turn the key to the on position to wait for the indicator lights (temp and oil pressure) to go off, then turn the key to...
Back
Top